Intermediate OEC Section 86 (EV Charging Equipment) Permit always required*

EV Charger Installation

Installing a home EV charger is really two questions in one: does your panel have the room, and what does the circuit itself need to look like? Here's how to think through both before you buy anything.

Read time: 10 min Applies to: Level 2 home charging

Level 1 vs Level 2, briefly

Level 1 — uses a standard 120V household outlet, included with most EVs. Slow (often 1 day's range or less overnight), but needs no new wiring at all.
Level 2 — runs on 240V, similar to an electric dryer or range circuit, and charges roughly 3–7x faster. This is what most homeowners mean by "installing an EV charger," and what the rest of this guide covers.

Step 1: does your panel have the room?

A Level 2 charger is one of the largest continuous loads you can add to a home's electrical system — often pulling 30–50A for hours at a stretch. Before buying a charger, you need to know two things: how much spare capacity your panel actually has, and whether there's physical space for a new double-pole breaker. This is exactly the load calculation covered in our Panels & Breakers guide — if your panel is already tight, the charger project becomes a panel upgrade project first.

Not sure if you have headroom?

Run your numbers through our EV Charger Load calculator before you buy a charger or book an install.

Try the calculator

What the circuit itself needs

A dedicated circuit — an EV charger should never share a circuit with other loads
Correct wire gauge for the amperage — undersized wiring on a continuous high-draw circuit like this is a genuine fire risk, not just a code technicality
A double-pole breaker sized to match, with the charger's amperage draw factored against the breaker and wire rating together, not just matched to one or the other
Weatherproof, GFCI-protected equipment if the charger is mounted outdoors or in an unheated garage

Hardwired vs. plug-in chargers

Some Level 2 chargers hardwire directly into the circuit, while others plug into a dedicated high-amperage outlet (commonly a NEMA 14-50). A plug-in setup gives you flexibility to swap chargers later without re-wiring, while hardwired units are often slightly more efficient and are required by some charger models. Either way, the circuit sizing question is identical.

The permit and inspection process

Load calculation confirming the panel can support the new circuit alongside existing loads.
ESA permit application, submitted before work begins — EV charging circuits always require one.
Circuit installation by a Licensed Electrical Contractor, sized correctly for the specific charger.
ESA inspection to certify the completed installation.

Why this isn't a DIY project

Between the continuous high-amperage draw, the panel capacity calculation, and the permit requirement, an EV charger circuit sits in the same category as a panel upgrade — it's a licensed electrician's job from the first step, not a "call a pro if it gets complicated" project. Getting the sizing wrong on a circuit that runs at high draw for hours every night is a much bigger risk than a typical DIY mistake.